A/C Wiring
Thread Starter
New to the Club!
Joined: May 2020
Posts: 1
Likes: 0
From: Florida
A/C Wiring
I have a s4 turbo ii and I deleted the emissions hardness from it and going to install my own standalone ecu. I was doing some searching but can’t understand what do I have to wire up for my a/c to get it to work, I need to know where the thermoswitch and low pressure switch goes and whatever else am I missing, pictures and wire colors help a ton sorry for the dumb question thanks!
its been so long I forget
I posted about it in the past and I believe someone else posted about it in the haltech section
let me see if i can find it
https://www.rx7club.com/2nd-generati...g-ecu-1101864/
I posted about it in the past and I believe someone else posted about it in the haltech section
let me see if i can find it
Rest of the system aside, such as type of charge, pressure switch, triggering the fan if you have an electric fan, fully operational logicon, etc and so forth
Wiring wise Just tie the BLUE/ORANGE and BLUE/WHITE wires together on the plug where the factory ecu was. I just used a small piece of wire and stuck it in there
My ac still doesnt quite work i have a leak somewhere but it did work pretty good for a little bit .
The amount of time and money i have into this crap makes me sick lol
Wiring wise Just tie the BLUE/ORANGE and BLUE/WHITE wires together on the plug where the factory ecu was. I just used a small piece of wire and stuck it in there
My ac still doesnt quite work i have a leak somewhere but it did work pretty good for a little bit .
The amount of time and money i have into this crap makes me sick lol
Thread
Thread Starter
Forum
Replies
Last Post
Jehuty77
2nd Generation Specific (1986-1992)
1
Aug 19, 2013 02:47 PM
Adam P
2nd Generation Specific (1986-1992)
11
May 30, 2006 05:57 AM