Better Gates
Seduced by the DARK SIDE
Joined: Apr 2001
Posts: 7,323
Likes: 2
From: Orange Park FL (near Jax)
The gate width is cast in iron & aluminum.
I have thought about narrowing the sides on the tip of the internal control lever.
That would make the gear selections, especially 3rd, a little wider target.
I have thought about narrowing the sides on the tip of the internal control lever.
That would make the gear selections, especially 3rd, a little wider target.
Locust of the apocalypse
Joined: Apr 2003
Posts: 2,553
Likes: 2
From: Directly above the center of the earth (York, PA)
You know what the biggest difference I found in shifting the car was??? I but Banzai Racing Poly Motor mounts in it.. I haven't missed 3rd from second at the strip since.
Seduced by the DARK SIDE
Joined: Apr 2001
Posts: 7,323
Likes: 2
From: Orange Park FL (near Jax)
After I installed a torque brace, my shifts got way better.
But now after installing a light flywheel & copper clutch, I have to completely retrain my shift habbits.
But now after installing a light flywheel & copper clutch, I have to completely retrain my shift habbits.
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
Oct 17, 2020 03:25 PM
eplusz
General Rotary Tech Support
15
Oct 7, 2015 04:04 PM