Backup light don't turn on. Where to start?
Thread Starter
Full Member
Joined: Jun 2002
Posts: 140
Likes: 0
From: Chicago North suburbs
Backup light don't turn on. Where to start?
When I put my car in reverse the backup lights do not come on. The bulbs check out OK, so I sure it something else. I'm not sure where to start. Any suggestions would be very helpful.
Tony
By the way, this forum ROCKS!!! All the problems I had with my RX-7 was fixed by someone on this forum. This forum it like a bible for RX-7. Just by reading and/or searching, I fixed problems I didn't know I had (eg. wiper switch relay replacement, resolder the cpu, etc....) BIG THANKS!!!!!
Tony
By the way, this forum ROCKS!!! All the problems I had with my RX-7 was fixed by someone on this forum. This forum it like a bible for RX-7. Just by reading and/or searching, I fixed problems I didn't know I had (eg. wiper switch relay replacement, resolder the cpu, etc....) BIG THANKS!!!!!
There is a relay on the drivers side of the tranny. towards the top - kinda hard to access. But start with the connections that come from the relay - clean them, make sure they are connected well. If not, then the actual relay may be faulty
Thread Starter
Full Member
Joined: Jun 2002
Posts: 140
Likes: 0
From: Chicago North suburbs
Originally posted by sunshine
There is a relay on the drivers side of the tranny. towards the top - kinda hard to access. But start with the connections that come from the relay - clean them, make sure they are connected well. If not, then the actual relay may be faulty
There is a relay on the drivers side of the tranny. towards the top - kinda hard to access. But start with the connections that come from the relay - clean them, make sure they are connected well. If not, then the actual relay may be faulty
Would that be in the same area as starter motor. I did notice some wires around that area.
yes there are seome arround the starter there should be four! clean them and connect them properly. Mine also did not work so it should all be good then, if not then you need a new relay, Mine work fine now!
Good Luck
Good Luck
Former Moderator. RIP Icemark.
Joined: Apr 2001
Posts: 25,896
Likes: 24
From: Rohnert Park CA
Originally posted by sunshine
There is a relay on the drivers side of the tranny. towards the top - kinda hard to access. But start with the connections that come from the relay - clean them, make sure they are connected well. If not, then the actual relay may be faulty
There is a relay on the drivers side of the tranny. towards the top - kinda hard to access. But start with the connections that come from the relay - clean them, make sure they are connected well. If not, then the actual relay may be faulty
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
