BAC to TP to Block Hoses
#1
BAC to TP to Block Hoses
So my thermal pellet that keeps the Throttle at 30% when cold is giving me some headaches. The hoses have very little heat in them, when warming up, 140* coolent temp these hoses are barely warm. Eventually it gets the TPS down to 20% but if i stop for even 10 mins the pellet has pulled back and my throttle is at 30% again. Then of course the car runs like crap for a few minutes.
I had the UIM off last week and made sure the passages into the tb and the bac where clear and they seemed fine.
I'm going to go put my pressure tester on it just to see if there is a leak.
I had the UIM off last week and made sure the passages into the tb and the bac where clear and they seemed fine.
I'm going to go put my pressure tester on it just to see if there is a leak.
Thread
Thread Starter
Forum
Replies
Last Post
24seven_dada
3rd Generation Specific (1993-2002)
20
11-10-18 12:03 PM