im doing a auto to manual transimssion swap and im wondering how to mount the clutch pedal? any thoughts would help out

 

there are predrilled holes in the chassie. pretty sure atleast

 

The chassis has stamps that you drill out. You're going to have to switch brake pedals too...

 

Save yourself a lot of grief and exchange the car for a MT car. There are many components that must be changed to do this conversion. But I wish you good luck anyway.

 

Just buy a pedal assembly from a MT car and knoickout the clutch master cylinder plug on the firewall. (bolted in IIRC)

 

yea i know about the little plastic covers, but i was wondering if it would be eayser to take the dash out to do it cause theres not a lot of room to work under the dash, and im just doing this for a project in school so i can graduate cause my school is now making a seinor project manditory, its shitty. but im putting in stage 2 clutch components and a 9 pound flywheel.

thanks