Auto-Manual Swap HELP PLEASE
Thread Starter
Newbie
Joined: Oct 2001
Posts: 2
Likes: 0
From: Albquerque
Auto-Manual Swap HELP PLEASE
I need help really bad. My Rx-7 is an 88 GXL and I am doing a Auto- Manual tranny swap. I thought had everything covered then I discovered that the mounts on the frame tunnel were in different locations, for the auto/manual. Has anyone every done this before, If so I could really use some suggestions on where to go from here. Should I fabricate new mounts, or try using the ones that are on there now. Thanks in Advance
Last edited by Oppressor; Oct 17, 2001 at 07:55 PM.
Senior Member
Joined: Feb 2001
Posts: 255
Likes: 0
From: White Rock BC
Best thing to do is get a new mount made. When I did it on a friends car they used the automatic mount, so it would bolt into the car, and mad a new mount inside it to bolt to the tranny. If I have his car in the air in the next few days I'll take a picture of it.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
gtcd
1st Generation Specific (1979-1985)
3
Sep 17, 2015 01:15 PM
gabescanlon
3rd Generation Specific (1993-2002)
2
Sep 15, 2015 06:57 AM
jakeishness
2nd Generation Specific (1986-1992)
11
Sep 11, 2015 11:33 AM
