Auto-Manual Swap HELP PLEASE
10-17-01, 07:51 PM
#1
Newbie
Thread Starter
Join Date: Oct 2001
Location: Albquerque
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Auto-Manual Swap HELP PLEASE
I need help really bad. My Rx-7 is an 88 GXL and I am doing a Auto- Manual tranny swap. I thought had everything covered then I discovered that the mounts on the frame tunnel were in different locations, for the auto/manual. Has anyone every done this before, If so I could really use some suggestions on where to go from here. Should I fabricate new mounts, or try using the ones that are on there now. Thanks in Advance
Last edited by Oppressor; 10-17-01 at 07:55 PM.
10-19-01, 09:05 PM
#2
Senior Member
Join Date: Feb 2001
Location: White Rock BC
Posts: 255
Likes: 0
Received 0 Likes
on
0 Posts
Best thing to do is get a new mount made. When I did it on a friends car they used the automatic mount, so it would bolt into the car, and mad a new mount inside it to bolt to the tranny. If I have his car in the air in the next few days I'll take a picture of it.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
gtcd
1st Generation Specific (1979-1985)
3
09-17-15 01:15 PM
gabescanlon
3rd Generation Specific (1993-2002)
2
09-15-15 06:57 AM
jakeishness
2nd Generation Specific (1986-1992)
11
09-11-15 11:33 AM
