hey there, according to section f1-82 of the teamfc3s manual at this link http://www.teamfc3s.org/main/factory..._non_turbo.pdf i got from pin E2 to pin Vc 281ohms and from E2 to THA 1601ohms but I couldn't get a reading from E2 to Vs. so does that mean my AFM is bad?

 

just got done testing that and for narrow range closed i got 1.89Kohms and for narrow range open i got 4.85Kohms. For Full range closed i got .73Kohms and for full range open i got 6.13Kohms. so its out of spec for one part of each range, does that call for a replacement TPS? Is there a way to adjust it back to specs?

 

My understanding is that if its over 6k on open, then its shot.

 

thanks, i guess i better start looking for a new one. Since the two readings i got for the afm were good and the no reading on the last two pins, does that mean i should start looking for another afm also?

 

No idea about the afm, I'm curious about that as well.