91 intake manifold on 86 motor?? Worth It?
#1
Senior Member
Thread Starter
Join Date: Jan 2003
Location: Nebraska
Posts: 478
Likes: 0
Received 0 Likes
on
0 Posts
91 intake manifold on 86 motor?? Worth It?
Is it really worth all the time it takes to do and the money? What do you all need? Do you need tps? Any info would help. Thanks
#2
still love the FC
Join Date: May 2002
Location: Dayton, Ohio
Posts: 360
Likes: 0
Received 0 Likes
on
0 Posts
Check out this post in the archive:
https://www.rx7club.com/forum/showth...threadid=95492
Depends on the cost I suppose, but there are some gains to be had.
Depends on the cost I suppose, but there are some gains to be had.
#5
Senior Member
Thread Starter
Join Date: Jan 2003
Location: Nebraska
Posts: 478
Likes: 0
Received 0 Likes
on
0 Posts
Is this everything I need?
1) The three sections of the 89 intake. (The Dynamic Chamber, Upper intake, and Lower intake)
2) The 6-port actuators from the 89 lower manifold
3) The VDI actuator
4) UPPER AND LOWER fuel rail from the 89
5) The mounting bracket that holds the dynamic chamber up
6) New manifold gaskets (throttle body to dynamic chamber (DC), DC to upper manifold, upper to lower manifold, and finally lower manifold to engine block.
7) An 89 BAC valve, but you will also need the electrical connector to use this piece.
8) A lot of carburetor cleaner!
9) new injector o-rings, upper grommets, and lower grommets
10) Other things that I purchased: new vacuum hose, some JB weld, and some new fuel line.
And if it is does anyone have all of this and how much for every item. I can buy carb cleaner and gaskets but I need the parts from a 89/91 that come on the car.
1) The three sections of the 89 intake. (The Dynamic Chamber, Upper intake, and Lower intake)
2) The 6-port actuators from the 89 lower manifold
3) The VDI actuator
4) UPPER AND LOWER fuel rail from the 89
5) The mounting bracket that holds the dynamic chamber up
6) New manifold gaskets (throttle body to dynamic chamber (DC), DC to upper manifold, upper to lower manifold, and finally lower manifold to engine block.
7) An 89 BAC valve, but you will also need the electrical connector to use this piece.
8) A lot of carburetor cleaner!
9) new injector o-rings, upper grommets, and lower grommets
10) Other things that I purchased: new vacuum hose, some JB weld, and some new fuel line.
And if it is does anyone have all of this and how much for every item. I can buy carb cleaner and gaskets but I need the parts from a 89/91 that come on the car.
Thread
Thread Starter
Forum
Replies
Last Post