1987 na fc build is just about complete, Just can't finish it, can you help?
So what I've done to the car is manual swapped it and am having trouble wiring the starter and routing the wiring harness.
To my understanding so far the spade is the starter trigger, the bolt on the left is positive, and the bolt on the right is wires going into the starter
So my question is for the negative connecter from the battery where do I put that, on the back bolt of the starter? , also for routing the harness the last holder by the starter is a metal bracket where does the bracket connect? another question is the spade connector i would have to run to the key, where on the ignition switch? (not necessary----), and if I have to do that is there a way I can add an extra hidden switch to deter theft?
on this thread the box thing, the wire on mine broke at the base of the box, where could I buy a replacement?
Ihttps://www.rx7club.com/new-member-rx-7-technical-256/starter-manual-trans-wiring-1083462/

 

the negative cable goes on the bellhousing bolt that is under the oil filter. (red arrow)
and the little bracket goes on the next one down (blue arrow)