5 beaps repeating, over and over!
Thread Starter
eureka_sa76
Joined: Dec 2003
Posts: 18
Likes: 0
From: south australia
5 beaps repeating, over and over!
Hi everyone, I recently changed my steering wheel for an aftermarket one, and the supplied boss kit is a little sus because I had to remove metal before I could even fit it on. Now, the indicator cancel ring, which used to be as smooth as a babies butt, feels like i'ts seizing intermittently, steering feel is stiff because of the indicator cancel ring, and, furthermore, since I fitted the aftermarket wheel, there has been a series of 5 beeps repeating, coming from under the dash, not sure if It's speed related, or steering related, haven't been able to drive the car long enough to sus it out properly yet. But this beep is not the same as the speed warning we get at 108km/hr (sorry if your not metric). Anyone add to this?
Bob
Bob
Trance Addict
Joined: Sep 2005
Posts: 67
Likes: 0
From: Nor Cal - Crescent City
Originally Posted by FAQ
I keep hearing a beep beep beep
Probably the power steering computer telling you there is a problem with the system. The number of beeps before pausing will indicate the problem.
1-beep, pause, repeat - in case abnormality of speed sensor signal:
In case broken wires or short circuits occur to sensors or harnesses, the buzzer sounds 60-seconds after the engine speed signal of 2200 rpm continues for 18-seconds.
2-beeps, pause, repeat - in case abnormality of engine speed signal:
The buzzer sounds twice and repeats when the vehicle speed signal is missing input and/or no engine speed signal is found (short circuit, broken wire, etc.)
3-beeps, pause, repeat - in case abnormality of stepping motor signal:
The buzzer sounds when there are broken wires or short circuits in coils or harnesses.
4-beeps, pause, repeat - in case abnormality of the power steering microcomputer:
The buzzer sounds 4 and repeats when there are circuit troubles other than with the micro computer.
5-beeps, pause, repeat - in case abnormality of steering sensor signal: Steering sensor is mis-aligned or failed or steering wheel has been improperly installed.
Probably the power steering computer telling you there is a problem with the system. The number of beeps before pausing will indicate the problem.
1-beep, pause, repeat - in case abnormality of speed sensor signal:
In case broken wires or short circuits occur to sensors or harnesses, the buzzer sounds 60-seconds after the engine speed signal of 2200 rpm continues for 18-seconds.
2-beeps, pause, repeat - in case abnormality of engine speed signal:
The buzzer sounds twice and repeats when the vehicle speed signal is missing input and/or no engine speed signal is found (short circuit, broken wire, etc.)
3-beeps, pause, repeat - in case abnormality of stepping motor signal:
The buzzer sounds when there are broken wires or short circuits in coils or harnesses.
4-beeps, pause, repeat - in case abnormality of the power steering microcomputer:
The buzzer sounds 4 and repeats when there are circuit troubles other than with the micro computer.
5-beeps, pause, repeat - in case abnormality of steering sensor signal: Steering sensor is mis-aligned or failed or steering wheel has been improperly installed.
Trending Topics
Trance Addict
Joined: Sep 2005
Posts: 67
Likes: 0
From: Nor Cal - Crescent City
Originally Posted by mazclubber
Thanks for the info Gxl90RX7, and Staticguitar313, anyone know if there's an exploded diagram available of the indicator/steering area? Bob
http://www.cochran-racing.com/FSM/s4/index.html
Joined: Sep 2005
Posts: 25,581
Likes: 136
From: Smiths Falls.(near Ottawa!.Mapquest IT!)
try this..what do you have to lose!
disconnect battery wait 5 minutes reconnect battery..help at all? resets itself ..wouldn't it...time on labor 6 minutes ..cost 0.
Thread
Thread Starter
Forum
Replies
Last Post
toplessFC3Sman
2nd Generation Specific (1986-1992)
6
Mar 20, 2018 01:54 PM
Adaptronic Cranking fuel table messed up?
sherff
Adaptronic Engine Mgmt - AUS
5
Sep 12, 2015 12:22 PM