I am building a 13b 4 port bridge port engine.

I am using a turbo engine with s5 na rotors.

Also planning on using Turbo intake with some mods.

Will be Haltech powered.

Using NO2.

Will 2mm seals be good enough? If yes which kind and why?

Any advice other than seeking mental health professionals and this is a waste of time greatly appreciated.

GregW

 

Sounds cool but I don't know about the seals.I heard that 2mm was fine on a N/A but I saw you plan on using nitrous so I don't know.Might run into the same tuning issuses as a turbo( running lean while on the bottle,detonation,etc.)so you may benifit from using 3mm.As for brands other than Mazda.I have no clue.I know they are out there but don't know anythng about them,maybe someone else does.