13B RE Exhaust ports -- anything to improve here?
#1
Rotary Enthusiast
Thread Starter
Join Date: Aug 2002
Location: Kansas
Posts: 1,273
Likes: 0
Received 0 Likes
on
0 Posts
13B RE Exhaust ports -- anything to improve here?
Lots of restriction here -- is there anything I can (should?) do about this? Specifically I'd like to do it w/o doing a complete teardown unless I absolutely have to.
#2
Glock Lover
Join Date: Mar 2001
Location: Currently residing in St Charles, MO
Posts: 2,223
Likes: 0
Received 0 Likes
on
0 Posts
No. Your not getting them out without taking the whole thing apart. The ports are fine man, dont sweat em. Ive already reseached this particular rubject. Theyre only worth replacing (with FD sleeves) if youre pulling the motor apart, even then theyre a bitch to switch. I personally wouldnt screw with them ever. Theyre fine.
#4
Rotary Enthusiast
Thread Starter
Join Date: Aug 2002
Location: Kansas
Posts: 1,273
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by rotary>piston
if you want to make them better you definitely need to tear down the engine. You don't want **** getting into the engine do you?
if you want to make them better you definitely need to tear down the engine. You don't want **** getting into the engine do you?
Thread
Thread Starter
Forum
Replies
Last Post