whats the best setup for HID's

Reply Subscribe

Thread Tools

Search this Thread

Apr 24, 2011 | 06:38 PM

#126

Rob XX 7

FC guy

iTrader: (8)

Joined: Oct 2002

Posts: 8,713

Likes: 17

From: Long Island, New York

i know a way to get my slight amount of clearance inside the light and eliminate the glass lens.
Going to have my plastic guy do it tomorrow

Apr 24, 2011 | 10:03 PM

#127

turboIIrotary

Rotary Freak

iTrader: (9)

Joined: Feb 2007

Posts: 2,618

Likes: 3

From: dayton,ohio

Quote:

Originally Posted by Rob XX 7

right now I have glass, these were my existing h4 conversion housings I had, nothing is sealed up I can swap them out to another housing.

you using plastic or glass? with plastic I bet I can put a small bubble in the lens for clearance and eliminate a spacer but I think it will look goofy

I am using a plastic lens, bubble lens looks out of place if you can make the whole lens taller it would look much better i tried to make a new one with my oven and some acrylic but it didn't work out too well.

Apr 25, 2011 | 12:34 PM

#128

Rob XX 7

FC guy

iTrader: (8)

Joined: Oct 2002

Posts: 8,713

Likes: 17

From: Long Island, New York

my plastic guy can make anything, I already have a simple low cost design in mind, it would look like stock.
They tell me they can be 2mm away from the cover, no worry about the heat.

May 19, 2011 | 05:39 PM

#129

Rob XX 7

FC guy

iTrader: (8)

Joined: Oct 2002

Posts: 8,713

Likes: 17

From: Long Island, New York

ive been super busy at work, this was put on the back burner- but here are my totally clear housings, the shroud is just sitting in there not fitted yet.

I think they look pretty good, no lines and no glass to distort the lighting