volvo 740 lip...go ahead and trash your 626 lip
#101
Google+ Is More Fun
Join Date: Mar 2012
Location: Folsom, CA
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
The problem with this lip though is it makes you fake low haha. You drag lip but everything else clears easy. Rock no lip and try and get the bumper at the same height hahaha.
#108
Google+ Is More Fun
Join Date: Mar 2012
Location: Folsom, CA
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Mehhh...takes time but they'll grow on you.
I looked into your threads to find a picture of your car to flame you for but holy hell your car is reallyyy clean. I'm impressed.
I looked into your threads to find a picture of your car to flame you for but holy hell your car is reallyyy clean. I'm impressed.
#120
troubleshooting sucks
a big cartman "GOD DAMMIT" just exited my mouth just now. i been running around like a blue-assed fly trying to get my hands on a pig-nose lip from a 200sx, finally found one which is gna cost me approx 150 dollars if you convert it from swedish crowns and then i find out that i could have put a volvo lip on. those things are a dime a dozen here aaaarghh i wanna cry
#121
FC guy
iTrader: (8)
a big cartman "GOD DAMMIT" just exited my mouth just now. i been running around like a blue-assed fly trying to get my hands on a pig-nose lip from a 200sx, finally found one which is gna cost me approx 150 dollars if you convert it from swedish crowns and then i find out that i could have put a volvo lip on. those things are a dime a dozen here aaaarghh i wanna cry
#122
Living on the North Coast
iTrader: (31)
I finally got around to installing the '90-92 Volvo 740 Turbo front lower valance tip. From the photos I have seen it appears to fit the bottom of the S4 bumper cover better than the S5. I had to trim off some alignment tabs from the top edge and had to re-contour the corners by cutting out thin pie shaped sections out and cutting slits in other places. I drilling the upper edge and reused the 12 factory screws. I used a hole punch to cut out rounds holes to fit over bolt hex heads. I made a bracket for attaching the center section out of aluminum stock, I need to make two more and then paint all of them black. I wiped the Volvo valance panel down with acetone and a rag to clean it and remove the oxidation so now it looks fairly good/new as well. All in all it came out fairly nice - is it prefect, no. With my near stock ride height, I have 4-1/2" of clearance and no issues going over the curb and onto the driveway apron nor pulling out of the driveway either.