Rotor Bearing check during rebuild
Thread Starter
Junior Member
Joined: Jun 2013
Posts: 39
Likes: 0
From: Portage, Mi
Rotor Bearing check during rebuild
Hi all,
Rebuilding a series 5 13b turbo to swap into my GTUS. Have a few questions regarding the rotor bearings. I did some searching on the site, and found lots of conflicting information about what to do about rotor bearings. I took a picture of the bearing in question. The engine was pulled at 90,000 miles due to low compression. Here is a link to the picture of the bearing: https://ibb.co/cx3mrH
Does it look like it can be reused? Or should it be swapped out?
Rebuilding a series 5 13b turbo to swap into my GTUS. Have a few questions regarding the rotor bearings. I did some searching on the site, and found lots of conflicting information about what to do about rotor bearings. I took a picture of the bearing in question. The engine was pulled at 90,000 miles due to low compression. Here is a link to the picture of the bearing: https://ibb.co/cx3mrH
Does it look like it can be reused? Or should it be swapped out?
Thread
Thread Starter
Forum
Replies
Last Post
Mitchsch94
2nd Generation Specific (1986-1992)
9
Sep 22, 2017 06:08 PM
petree_777
2nd Generation Specific (1986-1992)
22
Jan 30, 2016 10:13 AM