Installing S2 RX8 6-Speed in an FC
#53
Full Member
Thread Starter
Sorry, I didn't get see my reply notification.
Nothing has changed since I installed the transmission. It's gone through a couple dozen autocross events and survived without issues. I ended up having a custom driveshaft built because my U-joints were going out, and I wanted the perfect length rather than using the auto shaft which is about an inch short.
Edit: I already posted about the driveshaft, my bad.
The car is making around 400whp still and broke an axle stub, but the trans is keeping up so far.
Thanks!
Nothing has changed since I installed the transmission. It's gone through a couple dozen autocross events and survived without issues. I ended up having a custom driveshaft built because my U-joints were going out, and I wanted the perfect length rather than using the auto shaft which is about an inch short.
Edit: I already posted about the driveshaft, my bad.
The car is making around 400whp still and broke an axle stub, but the trans is keeping up so far.
Thanks!
Last edited by Hayamate; 03-14-22 at 12:21 PM. Reason: Redundancy
#54
Full Member
Thread Starter
As far as the drawings go, I haven't had the trans out since I installed it. So I don't have the dimensions for you. However, it was pretty simple to build the relocation bracket. The only thing special about the setup was extending the shift rod and having a cup machined for the ball of the shifter. If I ever have the trans out I will try to remember to get some measurements.
Thread
Thread Starter
Forum
Replies
Last Post
RotaryEvolution
2nd Generation Specific (1986-1992)
150
09-02-09 01:27 PM
coldfire
2nd Generation Specific (1986-1992)
24
10-11-06 02:50 PM