Boost/Pressure Sensor Stock Wiring Question
#1
Boost/Pressure Sensor Stock Wiring Question
The below picture is from my boost sensor (N318) on my S4 TII. I am sorting out an idling issue and noticed a couple of wires were disconnected from my boost sensor on the emission harness side. I have no clue how long they have been disconnected, but I want to put them back into the harness if they belong there.
Can anyone look below and tell me if I just need to put these back into their respective colors' connectors on the emission-side plug?
Forgive me for being wiring diagram dumb. I have been searching and just cannot find the correct page in the PDF. Thanks for any help.
Can anyone look below and tell me if I just need to put these back into their respective colors' connectors on the emission-side plug?
Forgive me for being wiring diagram dumb. I have been searching and just cannot find the correct page in the PDF. Thanks for any help.
Thread
Thread Starter
Forum
Replies
Last Post
Seven!!
General Rotary Tech Support
2
03-01-06 02:04 AM
HOZZMANRX7
General Rotary Tech Support
4
02-24-05 06:27 PM