Boost/Pressure Sensor Stock Wiring Question
The below picture is from my boost sensor (N318) on my S4 TII. I am sorting out an idling issue and noticed a couple of wires were disconnected from my boost sensor on the emission harness side. I have no clue how long they have been disconnected, but I want to put them back into the harness if they belong there.
Can anyone look below and tell me if I just need to put these back into their respective colors' connectors on the emission-side plug? Forgive me for being wiring diagram dumb. I have been searching and just cannot find the correct page in the PDF. Thanks for any help. https://cimg1.ibsrv.net/gimg/www.rx7...8b0baf3cda.jpg |
Well I re-inserted the red into red and black into black on the connector inside the plastic plug. I did not notice any change, but I assume that is how it is supposed to be.
|
That's a fuel cut defender and not a stock part. You should remove it.
|
All times are GMT -5. The time now is 12:10 PM. |
© 2024 MH Sub I, LLC dba Internet Brands