my bad... i wasn't paying attention when it all came apart and 2 of the dowels have a little machining done.

can anyone be a dear and tell me what positions they go back in? thanks!!!

 

they are from the front if i remember right.
matt

 

thanks.. but the thin part seemed a little loose in the front side housing... could it be the fat end goes there and the thin end goes into the fat intermediate?

 

yes that's the way it goes.
this allows for the front iron to align itself
its hard to explain but the rear half of the motor (rear 2 rotors) determine the shafts location
then the front rotor and housing mate up to the back half.
on later motors they didn't use these pins (better standards?)
matt

 

thanks a lot!
how late is "late"? this is a c-code.

 

I am not sure just want i was told. all the 20b's that i have seen apart have the step dowels

 

alright. well, the back 2 are done as of now.
it should be together by tonight

thanks again!