whoopsie, the dowels are different.
2 Attachment(s)
my bad... i wasn't paying attention when it all came apart and 2 of the dowels have a little machining done.
can anyone be a dear and tell me what positions they go back in? thanks!!! |
they are from the front if i remember right.
matt |
thanks.. but the thin part seemed a little loose in the front side housing... could it be the fat end goes there and the thin end goes into the fat intermediate?
|
yes that's the way it goes.
this allows for the front iron to align itself its hard to explain but the rear half of the motor (rear 2 rotors) determine the shafts location then the front rotor and housing mate up to the back half. on later motors they didn't use these pins (better standards?) matt |
thanks a lot!
how late is "late"? this is a c-code. |
I am not sure just want i was told. all the 20b's that i have seen apart have the step dowels
|
alright. well, the back 2 are done as of now.
it should be together by tonight :D thanks again! |
All times are GMT -5. The time now is 09:45 PM. |
© 2024 MH Sub I, LLC dba Internet Brands