Alright...I'm new to this sight and new to the world of RX-7s. I've always loved them, but never thought I'd own one, until recently. Both me and my best friend got one, but last night he blew his engine. It may not be completely blown, but we don't have enough experience with the rotory engine to know for sure what it would take to get it going and it doesn't look too promising.

I'm going to buy his from him more than likely, maybe for parts, maybe to rebuild, but I would really like to rebuild it. I would hate to see an RX go to waste...as I'm sure all of you feel the same on. I do not, however want to put the original 2-rotor back into it. My best friend says the only place I can get the 3-rotor is Canada and Australia, and not that I mind road trips, but does anybody know where I could get one in the states or more specifically in Canada? Or does anybody have any suggestions period?

I'm just a young gun with a tight budget, so I appreciate the advice very much!
Thanks.

 

Shane usually has one at www.rotaryworks.com

 

if ur on a tight budget.....3 rotor isnt for you.....no offense or anything..but u're looking at atleast a 15k project if u decide to do a 3 rotor..and yes....people do sell 3 rotors online....usually around 2-3k

 

A 3 rotor conversion will cost you ATLEAST $10,000. So you can forget it if you are on a tight budget. Do yourself a favor, read the FAQ do a few searches, ask questions in threads related to your problems/question. This has been talked about a lot. In fact, there's an entire section of the forum dedicated to this. All you had to do was a little bit of searching.

Before you get angry and saying you didn't know, go back to where all the threads are and there is a sticky for ALL NEW PEOPLE. If you didn't see that then you suck at the internet.

 

i was just about to say shane. he's normally always go them Good luck on the project. I hope you know that your going to be putting in some serious money

If you get a 20b it would be wise to rebuild it and if i am not mistaking the rebuild kit for it is around 2-3k. from what ive heard A total project if you did all the work yourself your looking at about 10k if you have a shop do it your lookin at 15-20

 

Try fc3s.org, they sometimes have something like that around .

 

What's with the tiny font?!??!?!

With the above statement, you should give it up.
http://fc3spro.com/TECH/SWAP/COSMO/20b.html


-Ted

 

LMAO...thats almost as good as...

"I beat the internet, the end guy was hard."

 

Good luck finding a good 20b in Ontario Canada. I called 5-6 places that i deal with and no one had a 20b instock and didn't know when they could get another one. One place got me one from japan that was blown and it took them 3 month to find it.