where to buy a 20b SS exhaust manifold?
We can make one too 
.
.
Thread Starter
In rotor we trust!
Joined: Aug 2004
Posts: 258
Likes: 0
From: Moscow, Russia
This is what the A-Spec one looks like. (I hope its ok I'm posting this Sean)
Pic 1:
This was the very first one Sean made, and he didn't know where the WG runner was going to end up, so he left it long. I just chopped it and welded the flange on where I needed it to be.
Pic 2: Installed. I had my LIM lowered (1in.), so the turbine housing was hitting the UIM flange, so i just chopped off the section it was touching. It was just extra UIM flange material, no LIM aluminum was removed. No fitment problems when it was stock height.
Pic 1:
This was the very first one Sean made, and he didn't know where the WG runner was going to end up, so he left it long. I just chopped it and welded the flange on where I needed it to be.
Pic 2: Installed. I had my LIM lowered (1in.), so the turbine housing was hitting the UIM flange, so i just chopped off the section it was touching. It was just extra UIM flange material, no LIM aluminum was removed. No fitment problems when it was stock height.
Trending Topics
That A-spec unit does not look bad, but I like this one that KIWI-RE made not sure if they are mass producing it though. Third pic in link
http://www.nopistons.com/forums/inde...hl=kiwi+racing
http://www.nopistons.com/forums/inde...hl=kiwi+racing
Full Member
Joined: Sep 2006
Posts: 246
Likes: 0
From: Ohio
Don't foget us, Defined Autoworks. We also sell a header. Just call us or send either GTORX7 or I a PM. Depending on what your set-up is/desire we can make a one-off header/turbo manifold for you.
Jackson
Jackson
Thread
Thread Starter
Forum
Replies
Last Post
