Intermediate Plate Width

Reply Subscribe

Thread Tools

Search this Thread

Mar 28, 2006 | 07:17 PM

drivelikejehu

Thread Starter

penurious

Joined: Nov 2005

Posts: 578

Likes: 0

From: College Park, Maryland

Intermediate Plate Width

does anyone know, or can anyone measure (with calipers, or something as accurate) the EXACT width of a 20B intermediate plate?

Mar 29, 2006 | 08:13 AM

CCarlisi

Rebreaking things

Joined: Jun 2001

Posts: 2,586

Likes: 0

From: 1 foot in Boston 1 in NJ

I haven't measured it but I believe it is 80mm.

Mar 29, 2006 | 09:05 AM

rotary crazy

Full Member

Joined: May 2003

Posts: 182

Likes: 0

From: Santiago, Dominican Republic

I dont have any equipment to mesure, wish I could help

is this for your project?

Mar 29, 2006 | 11:23 AM

drivelikejehu

Thread Starter

penurious

Joined: Nov 2005

Posts: 578

Likes: 0

From: College Park, Maryland

^yup

we have an idea... kinda out of the box, but it should work.

Mar 29, 2006 | 02:39 PM

drivelikejehu

Thread Starter

penurious

Joined: Nov 2005

Posts: 578

Likes: 0

From: College Park, Maryland

also, can anyone supply a photo of an intermediate plate? specfically the center of it where the stationary gear goes.

Mar 29, 2006 | 03:22 PM

drivelikejehu

Thread Starter

penurious

Joined: Nov 2005

Posts: 578

Likes: 0

From: College Park, Maryland

^nvm, found what i was looking for

is the center hole in the plate larger so that the flange on the stationary gear can slide through and bold up inside the plate?

Mar 30, 2006 | 06:58 AM

rotary crazy

Full Member

Joined: May 2003

Posts: 182

Likes: 0

From: Santiago, Dominican Republic

Quote:

Originally Posted by drivelikejehu

^yup

we have an idea... kinda out of the box, but it should work.

I hope it works, good luck!

Reply Subscribe

Related Topics

Thread

Thread Starter

Forum

Replies

Last Post

My first rotary almost caught fire...plan for it not to happen again

ls1swap

3rd Generation Specific (1993-2002)

Jun 3, 2024 03:25 PM

wiring S4 TII to 5 TII help...

Sethix

2nd Generation Specific (1986-1992)

Nov 3, 2017 11:48 PM

RX7 turns over, then dies out.

Prediict

2nd Generation Specific (1986-1992)

Nov 18, 2015 08:41 AM

84SE Engine Swap Success! Surge at idle, clutch out.

LongDuck

1st Generation Specific (1979-1985)

Oct 7, 2015 08:12 PM