20b tension bolt pattern question
#1
Rotary Enthusiast
Thread Starter
iTrader: (3)
Join Date: Dec 2004
Location: New Jersey
Posts: 802
Likes: 0
Received 0 Likes
on
0 Posts
20b tension bolt pattern question
I was wondering if there is a certain pattern as to tightening the tension bolts like there is on the 13b. The 20b is obviously different, but is there a certain pattern i must follow to tighten these tension bolts??? if so, does anyone have something that i can follow to do this?
#5
Rotor Head Extreme
iTrader: (8)
Originally Posted by IronMdnX
I used the same patern at the FD 13b. If there was a corrisponding front bolt I would tighten it right after the rear.
Ah so basically when you torqued a rear short bolt, you would then tightend the same corrisponding bolt on the front side?
Last edited by t-von; 12-07-05 at 07:43 PM.
Thread
Thread Starter
Forum
Replies
Last Post