4sfeedit

Hi guys just some fun stuff going on here at Forcefedracing.ca

30psi put us just over the 1k hp mark.

Enjoy

http://www.youtube.com/watch?v=kNcdMGm_Jsk

allrotor93

iTrader: (126)

what turbo? porting?

GOTPAM?

charlies7

iTrader: (4)

I just made a mess....

LoU "hOw Ya Do"

iTrader: (7)

i think i just went from six to midnight...

t-von

iTrader: (8)

I know this engine is dowel pinned and drysump (which helps make the block more solid). What apex seals is it running? What series engine and it is running an aftermarket e-shaft? It's really nice to see a rotary making this kind of power with possibly not that many internal mods.

Slevin_FD

iTrader: (26)

I was doing the shop to shop networking thing a few weeks back, and he can offer that tune for a really decent price. I think there are gonna be alot more high HP 20Bs running around now depending where the boost kicks in and the cost of the turbo needed.

4sfeedit

Turbo is a custom 88mm T4, something that our turbo sponsor built for us.. Unusual but works unreal! Full spool by 4300

Engine is stock internally B seriess engine, stock crank factory syle dowell pins.
Secondary bridgeport.....

We have a handfull of street 20b cars rippin around on 700 with no problems..

Just keep an eye on the important guages and have faith in your tuner and some good depends!!! LOL

t-von

iTrader: (8)

Wow stock e-shaft? I knew the letter series engines had the better e-shafts but, I didn't expect them to be able to hold up at this kind of power. That's amazing!

Chuck Norris FB

Not bad numbers,if you don't mind me asking at what rpm hp peaked?

4sfeedit

7200-7400rpm

jtspells

When is that thing going to go down the strip?

4sfeedit

Not sure.... The car lives in Saskatchewan, and the owner when he is ready will take it down the track.

We were going to take it down the track and the owner changed his mind, as anything could happen at the track.

We are just going to have to wait.

Chuck Norris FB

Wow at those peak rpms that 20b is gonna last a long time

zayrx7

Why is there no torq. reading and what was it

4sfeedit

I dont use the inductive pickup on rotaries making big power/boost. It sometimes interupts the cycle of spark. This can cause pre-ignition.

61620B

what kinda gas u guys using?.......sounds really good Keep it up.

RZMotorsports

congratulations on the 1000hp. I be also taking mine soon to the dyno to finish what i started the 1000hp but when i had it in the dyno the tires were slipping and i was running out of injectors so i am making a couple of changes like diff, axles ect to take it back and make the 1000hp +. again congrats its a very great goal. We should make a shirt like they do at salt flats when you go over 200mph.

bewtew

iTrader: (7)

Nice numbers! I'm coming for you guys

COZMIC

thats damn impressive

rotarynerdette

iTrader: (5)

WoW amazing!

OneRotor

iTrader: (3)

damn impressive guys.

4sfeedit

Thanks for the props... Canadian eh!

rotorooter93fd

iTrader: (6)

what kind of fuel? E85, Q16?

4sfeedit

50/50 c16-94 chevron with meth injection, we dont hav e85 here...