ok i replaced the rubber in a friends -se sat. and now the glass keeps poping out of the track and no mater how i ajust it it keeps doing it. any ideas? i also replaced the 2 plastic clips that hold the glass to the reg.

 

Is the window frame bent ? How far up does it go to before it goes off the track ?

 

if i dont help it the glass is 1/2" off the fack of the frame when its 3" or so up. as far as i can tell all the parts are in great shape

 

My passenger window does the same thing after I replaced the rubber..............I replaced the motor with a better one...........Goes up and down at a stop OK..but with wind resistance..........
driving..........it wont go up all the way.........tilts...

I think you need a new motor to overcome the tight fit
of the new rubber..........I adjusted the window for hours
till I finally got it to this level.........You can fine tune the tracks with the bolts in the door...I pulle the window back to force it in the porper position and then adusted the window guides.....had to tweak it ...and tweak it.....

 

This happened to my GSL when I replaced the outside window seals. I took the panel off and put it back on the runner but it came off again after a few days. Next time I carefully bent the front runner in a bit so that it made better contact with the window. This fixed the problem and it has worked fine for the last couple months. A word of caution, if the window is binding or off the racks it will seem as if the motor is going bad. However the motor is working fine (unitl you burn it out, of course), it just can't push against the binding window.
Ray