Turbo II swap in 1st gen.
#1
Junior Member
Thread Starter
Join Date: Sep 2005
Location: Buffalo, New York
Posts: 49
Likes: 0
Received 0 Likes
on
0 Posts
Turbo II swap in 1st gen.
Ok i am planning on swapping a Turbo II engine into my first gen. there are a few questions that i would like to ask. First off, would i need to do any modifications to my car or would it be a clean swap? second, I am finding engines and trannys but these engine come with a cut wiring harness. Where can I find a wiring harness that is not cut? These questions may seem dumb but this car would be my first turbo and rotary car, and i want to do it right without cutting any corners.
Now i have heard of Haltech and Microtech standalone systems. Does these systems replace a stock ecu and wiring harness or would i need to still use the ecu and harness they give me with the engine? if anyone would be willing to help a brotha out, please holla back at me....any information would be benificial. thanks
Now i have heard of Haltech and Microtech standalone systems. Does these systems replace a stock ecu and wiring harness or would i need to still use the ecu and harness they give me with the engine? if anyone would be willing to help a brotha out, please holla back at me....any information would be benificial. thanks
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
craaaazzy
Comments and Suggestions Archive
3
08-21-15 02:00 PM