I'm doing a TII swap in my SA. I installed a gsl-se gas tank. I want to run brand new hard fuel lines from the tank to my walbro in-line then to the eng bay.. Also where should i install a filter? use a stock gsl-se filter? On the GSL-SE is the filter after the fuel pump unlike the carb model? any info on doing this will be helpfull. I'll be runing around 350 RWHP or so and want a fuel setup that will do this.. Thanks

 

Use a low pressure filter before the pump and a high pressure filter just before the fuel rail in the engine bay.

 

efi or carbed swap???

if its efi dont use a low pressure filter anywhere in your system.

 

It's a FI system.

 

There is no pressure before the fuel pump. I thought that was obvious.

Whether it's EFI or carb is irrelevent in this case as most people use a high pressue pump with their blow-through setups anyway.

 

What should I do about the fuel feed line? Run aftermarket fuel feed line to primary rail?

 

Keep the stock primary rail, and get a larger secondary rail.

NOTE: If you get an -AN 6 fuel line/rail - that is actually smaller than stock FD.