1st Generation Specific (1979-1985) 1979-1985 Discussion including performance modifications and technical support sections

smog test failure :(

Thread Tools
 
Search this Thread
 
Old Mar 11, 2005 | 06:40 PM
  #1  
javpowell's Avatar
Thread Starter
Junior Member
Tenured Member 05 Years
 
Joined: Mar 2005
Posts: 25
Likes: 0
From: Orange County, CA
smog test failure :(

I realize that this is a much talked about topic but I am sooo close now to passing

I went to a test only with my 85 rx7 and was labeled a gross poluter

Had the cat's replaced today and it droped my emissions by half, no longer a gross poluter...but still failed the test

Dont have any after market or differences to the engine...is there any way I can make it pass? I heard something about bypassing some tubes from the carb to help it out...any ideas?

BTW i am very new to the mazda rotary realm so please explain thoroughly if you have any suggestions

Help will be much appreciated

RX-7 Newb,
Jason
Reply
Old Mar 11, 2005 | 06:49 PM
  #2  
Rotor13B's Avatar
Wassup!!
Tenured Member 15 Years
 
Joined: Jul 2001
Posts: 1,081
Likes: 1
From: Longmont Co.
You should post your results of the test so others can evaulate it and point you in the right direction.
Reply
Old Mar 11, 2005 | 07:00 PM
  #3  
Zyrano's Avatar
Rotary Enthusiast
Tenured Member 05 Years
 
Joined: Dec 2004
Posts: 1,025
Likes: 0
From: Campbell, CA
Hey, I just went through this last month... where are you failing, or are you failing all of it? I'd check the acv, and if it is a carbed car, and i'd find a place to fine tune the carb if you are failing at idle. also what kinda cat did you get? at last, you need to have the car piping hot to pass (ie drive it for a while right before the test...

Alvin
Reply
Old Mar 11, 2005 | 07:03 PM
  #4  
javpowell's Avatar
Thread Starter
Junior Member
Tenured Member 05 Years
 
Joined: Mar 2005
Posts: 25
Likes: 0
From: Orange County, CA
15 MPH HC Max 148 Mine 180 CO Max .89 Mine 1.2
25MPH HC Max 123 Mine 145 CO Max .69 Mine .9
Reply
Old Mar 11, 2005 | 08:43 PM
  #5  
javpowell's Avatar
Thread Starter
Junior Member
Tenured Member 05 Years
 
Joined: Mar 2005
Posts: 25
Likes: 0
From: Orange County, CA
anything else? gonna retest it tomorrow, plzzz help
Reply
Old Mar 11, 2005 | 08:48 PM
  #6  
Zyrano's Avatar
Rotary Enthusiast
Tenured Member 05 Years
 
Joined: Dec 2004
Posts: 1,025
Likes: 0
From: Campbell, CA
are you running the air pump, because i think you need to have fresh air in the cat. I still say check the acv, and where did you get the new cats?, ie what brand are they?
Reply
Old Mar 12, 2005 | 12:18 AM
  #7  
Rx-7Doctor's Avatar
Lives on the Forum
Tenured Member 10 Years
iTrader: (13)
 
Joined: Jul 2004
Posts: 10,584
Likes: 12
From: Oregon
Smog

Originally Posted by javpowell
anything else? gonna retest it tomorrow, plzzz help
Just checking to make sure that your plugs are fresh, the wires are in good shape,
also the cap and rotor. Also the air filter too. Make sure you have no vacuum leaks anywhere. Also can run some alcohol in the system. Make sure that you time the test so that your engine and cat are still hot. That means take it on the freeway and run it for 20 minutes before you go in and dont shut the engine off. I have never had a carbed 1st gen fail after it was tuned and had a new main cat on it.
Good luck, rx7doctor
Reply
Old Mar 12, 2005 | 02:13 PM
  #8  
javpowell's Avatar
Thread Starter
Junior Member
Tenured Member 05 Years
 
Joined: Mar 2005
Posts: 25
Likes: 0
From: Orange County, CA
thanks doc

umm what kind of alcohol/ratio would i use?
Reply
Old Mar 12, 2005 | 04:15 PM
  #9  
javpowell's Avatar
Thread Starter
Junior Member
Tenured Member 05 Years
 
Joined: Mar 2005
Posts: 25
Likes: 0
From: Orange County, CA
wish me luck guys, gonna try smogging my car once more
Reply
Old Mar 12, 2005 | 10:19 PM
  #10  
kiker14's Avatar
finally back in an RX-7!!
Tenured Member 15 Years
iTrader: (1)
 
Joined: Jun 2003
Posts: 847
Likes: 0
From: Northern New Jersey
i just passed with my gsl-se... but nevertheless, i put in two 12 oz. bottles of dry gas (any auto parts store will have it) i don't have a ratio for you, but the car WILL run rough once it starts burning that alcohol, don't punch it at all while that stuff is being burnt, and re-fill entire tank once you are done with the test (if u do the dry gas trick)
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
BUSTN
General Rotary Tech Support
1
Sep 21, 2015 05:01 PM
Mps_hell
Adaptronic Engine Mgmt - AUS
3
Sep 19, 2015 10:02 PM
Erosangel
3rd Generation Specific (1993-2002)
5
Sep 18, 2015 04:06 PM
JP's 93 fd
3rd Generation Specific (1993-2002)
5
Sep 16, 2015 01:12 PM




All times are GMT -5. The time now is 05:53 PM.