Screw Cap Source
#1
Senior Member
Thread Starter
Screw Cap Source
Anyone have a source for the black plastic screw caps for the metal strip between dash and window? It’s a friction fit so would love to find some that have been verified to fit. Thanks!
#2
Happy Rotoring!
iTrader: (13)
Both the screws and cap have their own P/N's on the fische. The cap is 8871-60-701, but doesn't seems to be available in the system. (surprise). The screw measures .380 dia. (3/8) X .080 high. The cap is again .380 on its I.D. and about .09 deep. You could turn these out pretty quick on a lathe, or there always seems to be someone parting out a car on FB.
#3
Senior Member
Thread Starter
Got it found some hinged versions on McMasters that will be tolerant of inexact sizing. And less likely to fly across the garage when pried loose!
#5
Senior Member
Thread Starter
oh, and size small for the caps.
The following 5 users liked this post by Slow_sevens:
Banzai (09-28-23),
chirmstream (09-28-23),
Frogman (10-04-23),
Seniorchief (09-28-23),
VA RX7 (09-27-23)
Thread
Thread Starter
Forum
Replies
Last Post
t24todd
2nd Generation Specific (1986-1992)
6
01-25-09 07:02 PM
rotarypower83
1st Generation Specific (1979-1985)
3
02-08-04 05:37 PM