Hey guys my oil cooler on my se took a crap but the lines are still good. So my question is can i use a s4 oil cooler on my gsl-se? I know that i will have to make mounting brackets because i can get a s4 oil cooler with the lines for cheap. So how would i hook it up will my gsl-se lines fit and be long enough? Or if i have to swap to the s4 lines? And if i do swap to the s4 lines will they be long enough?
Any help would be greatly appreciated. I have to get this going Because it is my daily driver and at the moment I have nothing to drive.

 

I have an fc oil cooler(not sure what series) in my fb and the lines between the fb and fc
are different as the one for the fc uses banjo bolts. I believe the fc lines should work or
you can go to an fittings and braided lines.
Here's a few pick of my fc oil cooler set up:

In this one notice the banjo fittings that go into the fc oil-cooler as compared to the se
and sa fmoc fittings,

 

https://www.rx7club.com/showthread.p...highlight=fmoc

 

I think a lot of parts stores that make tractor hydraulic lines may be able to make you some custom lines if you have your fittings.

 

Put an fc cooler in and had some lines made it works great thanks for all of the help