ok i have read how to build a hi power turbo 12a, most of that will be done.. but i have a few questions about my goals and what i want to use..

1. i want to have approx 300 hp..
2. I want to stay stock port
3. i want to stay carb.. whats the best carb for this.. can i use a holley kit?
4. with my goals do i need the stronger rear plate? they are hard to find..
5. i already have a holley red pump on the car and FPR.. good enough?
6. I have a FMOC already on the car.. did this year come with them? (car had
mods previously done but not sure what yet)
7. I really dont plan on going above 7500 rpm should i still race clearance?
8. What turbo would be the best to use.
9. Im doing a full rebuild internally...where should i buy the kit from Mazda?
10. Im going to mod the OMP to pump 2 cycle from a seprate res.
11. Already removed the AC.
12. I want to use the gilmer drive belt set from Tweakit... any pros/cons of this?

well this is what i can think of so far input would be great..

 

https://www.rx7club.com/1st-generation-specific-1979-1985-18/12a-turbo-vets-yea-someones-asking-q-again-686044/

 

wow, turbo must be on alot of rotorheads minds, i cant make this stuff fast enough!! thank god for turbos!!
pm me with some questions so i can point you in the right direction my friend!
dont forget to eat lots of cheese

 

Your getting the Royal treatment. The Guru of 12a Turbos is on the ball.

What's up Robert. Keep the Turbos rolling out.

 

woo hoo i feel special lol pm will be coming your way

 

im definatly not on the ball, im just using lots of cheese too keep me afloat, lol

 

Who doesnt love cheese!!!!

 

lizards and vegans dont like cheese