sa7

iTrader: (13)

I'm rebuilding my brother's s5 t2 engine for his 82. I found one broken apex seal on the rear rotor that didn't cause any damage at all. I also found one broken apex seal on the front rotor that apparently gouged the front housing. I'm not sure if I can still use it or if I should replace it?


Thanks for the help

rotornoob

iTrader: (2)

Sweet jesus that looks deep. Id say toss it and get a new one.

j_tso

iTrader: (2)

Definitely not.

When you're checking housings, anything you can catch your finger nail on is not good.

j9fd3s

iTrader: (3)

trash it.

rotaryjunkee

That looks fine a little jb weld and your good to go, (lol j/k)

sa7

iTrader: (13)

The pictures were taken up close and it probably looks worse than it is. But I knew it was no good, I was just bummed when I saw that last night. My brother has already started looking for a good housing

Thanks for the help!