Rear axle carrier question
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Apr 2005
Location: Marlborough,Ma
Posts: 266
Likes: 0
Received 0 Likes
on
0 Posts
Rear axle carrier question
Well Just got my stimulus check and decided to do a litlte work on the GSL-SE.
I will be replacing the clutch, pressure plate, throw out bearing, while I am down there my rear end has been howling. I have replaced my rear wheel bearings in hopes it was that but, no luck
My question is I am looking to replace my rear axle carrier and all it's components. Now those the whole thing just bolt off of the rear end and I can just place the new one in, or is everything gonna fall apart..
I checked the service manual, but it seems as though it all comes out as one unit. I am asking to be sure this is something I can do without screwing things up... thanks ahead for al the help.
Cruz
And if any one has a good unit I am looking to buy in florida only..... Thanks
I will be replacing the clutch, pressure plate, throw out bearing, while I am down there my rear end has been howling. I have replaced my rear wheel bearings in hopes it was that but, no luck
My question is I am looking to replace my rear axle carrier and all it's components. Now those the whole thing just bolt off of the rear end and I can just place the new one in, or is everything gonna fall apart..
I checked the service manual, but it seems as though it all comes out as one unit. I am asking to be sure this is something I can do without screwing things up... thanks ahead for al the help.
Cruz
And if any one has a good unit I am looking to buy in florida only..... Thanks
#3
Senior Member
Thread Starter
iTrader: (1)
Join Date: Apr 2005
Location: Marlborough,Ma
Posts: 266
Likes: 0
Received 0 Likes
on
0 Posts
Thank you so much, I am assuming this will get rid of the howling the 2 rear axle shafts looked great when I took them out to replace the wheel bearings, so basically this should fix the problem I hope. I checked u-joints and a few other things you guys recommened, this seems to be the last thing.........
#4
Too old to act my age
Join Date: Feb 2005
Location: Tulsa, Ok.
Posts: 3,164
Likes: 0
Received 0 Likes
on
0 Posts
The axles do not have to be removed from the housing, but they do need to pulled out 3-4 inches.
Hopefully, a new carrier assembly will solve the howling.
Hopefully, a new carrier assembly will solve the howling.
Thread
Thread Starter
Forum
Replies
Last Post