ran into a snag
#1
Slide Or Die
Thread Starter
iTrader: (3)
Join Date: May 2004
Location: Dayton, OH
Posts: 1,076
Likes: 0
Received 0 Likes
on
0 Posts
ran into a snag
well the engine i took apart that had been in my back seat for about a year turns out while i was cleaning everything up that the housings are bad.. they have about a 2-3" line about 1 cm wide along the edge that is chipped off.. so i figure that would be a big problem.. so i am not sure what to do now.. i hear you cant get them re-surfaced.. i dont know what my options are besides trashing that project and finding another route.. let me know what you think..
its not effecting the car at this point because i still have the 12a in it and it still runs.. i was building the 13b into a half bridge port.. that was my goal.. but if i cant do anything about my housings i will either find another 13b to port.. turn the 12a into a turbo 12a... after rebuilding it ... or find a turbo II from a second gen or somthing.. oh well let me know what you think.
its not effecting the car at this point because i still have the 12a in it and it still runs.. i was building the 13b into a half bridge port.. that was my goal.. but if i cant do anything about my housings i will either find another 13b to port.. turn the 12a into a turbo 12a... after rebuilding it ... or find a turbo II from a second gen or somthing.. oh well let me know what you think.
#6
Slide Or Die
Thread Starter
iTrader: (3)
Join Date: May 2004
Location: Dayton, OH
Posts: 1,076
Likes: 0
Received 0 Likes
on
0 Posts
well maybe we can work it out.... you live a bit up north for me.. but its cool.. we should find a bunch of parts together and then early spring help eachother work on the cars.. it would be a good time..
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
FC3S Timmy
2nd Generation Specific (1986-1992)
16
10-03-15 01:08 AM