Question.... Searched first
#1
Full Member
Thread Starter
Join Date: Sep 2005
Location: Birmingham, AL
Posts: 106
Likes: 0
Received 0 Likes
on
0 Posts
Question.... Searched first
I am looking for the best source for a clutch pressure plate, throw out bearing and guide for an FB. Also any advice on trouble I might run into would be helpful.
Thanks
Rick
Thanks
Rick
#2
Racing is life!
iTrader: (2)
Join Date: Jan 2003
Location: Grapevine, TX
Posts: 2,173
Likes: 0
Received 0 Likes
on
0 Posts
This is a good site for general info http://www.mazdatrix.com/f-writng.htm . They also sell parts and are very good.
This is a good thread regarding suppliers https://www.rx7club.com/showthread.p...ghlight=gotham
One of my favorite resources http://members.ij.net/mrmazda/interchange.html
There is no "best" supplier. One word of advice on the pilot bearing. Unless you have a proper puller I would not change it unless it's shot. Inspect it, regrease it and leave it alone. Other than that doing a clutch is simple. That is unless you want to pull the flywheel and have it resurfaced
This is a good thread regarding suppliers https://www.rx7club.com/showthread.p...ghlight=gotham
One of my favorite resources http://members.ij.net/mrmazda/interchange.html
There is no "best" supplier. One word of advice on the pilot bearing. Unless you have a proper puller I would not change it unless it's shot. Inspect it, regrease it and leave it alone. Other than that doing a clutch is simple. That is unless you want to pull the flywheel and have it resurfaced
Last edited by cpa7man; 12-07-05 at 05:00 PM.
Thread
Thread Starter
Forum
Replies
Last Post
FC3S Timmy
2nd Generation Specific (1986-1992)
8
10-02-15 08:08 AM