project:boosted series3
#1
Full Member
Thread Starter
Join Date: Apr 2005
Location: AUCKLAND, NEW ZEALAND
Posts: 51
Likes: 0
Received 0 Likes
on
0 Posts
project:boosted series3
hey guys after a few months of being screwed around by losers, while i was trying to find a 13b carbed engine for my seven. i have finally given up and decided to install a series5 13bt. ive searched a alot of info on the swap and have made a list of things i'll need to do, just wana check im on the right track
ill need: 13bt
12a turbo front plate
manifold to move turbo forward
haltech computer (just cause i dont wana wire the pig+the
performance )
3" inch? turbo back exhaust
what driveshaft will i need to use (i have a series3 lsd)
will std gearbox mounts be useable?
wot type of fuel pump would be good
cheers for any replys joe
ill need: 13bt
12a turbo front plate
manifold to move turbo forward
haltech computer (just cause i dont wana wire the pig+the
performance )
3" inch? turbo back exhaust
what driveshaft will i need to use (i have a series3 lsd)
will std gearbox mounts be useable?
wot type of fuel pump would be good
cheers for any replys joe
#4
Altered Beast
Join Date: Jan 2003
Location: Arlington, VA
Posts: 399
Likes: 0
Received 0 Likes
on
0 Posts
https://www.rx7club.com/1st-gen-archive-71/engine-tii-swap-into-gsl-se-108398/
Driveshaft will need to be custom if using a TII transmission, modified/spaced mounts are needed, along with modification of the shifter. As far a fuel pumps, any good name brand should be fine; Bosch, Aeromotive, Denso, etc.
Driveshaft will need to be custom if using a TII transmission, modified/spaced mounts are needed, along with modification of the shifter. As far a fuel pumps, any good name brand should be fine; Bosch, Aeromotive, Denso, etc.
Thread
Thread Starter
Forum
Replies
Last Post