project:boosted series3
 

hey guys after a few months of being screwed around by losers, while i was trying to find a 13b carbed engine for my seven. i have finally given up and decided to install a series5 13bt. ive searched a alot of info on the swap and have made a list of things i'll need to do, just wana check im on the right track

ill need: 13bt
12a turbo front plate
manifold to move turbo forward
haltech computer (just cause i dont wana wire the pig+the
performance :D )
3" inch? turbo back exhaust

what driveshaft will i need to use (i have a series3 lsd)
will std gearbox mounts be useable?
wot type of fuel pump would be good

cheers for any replys joe :D

Im doing somthing similiar w/my 12A im using the turbo of an FC, mani, ic, etc.

bump please can i get some help

https://www.rx7club.com/1st-gen-archive-71/engine-tii-swap-into-gsl-se-108398/

Driveshaft will need to be custom if using a TII transmission, modified/spaced mounts are needed, along with modification of the shifter. As far a fuel pumps, any good name brand should be fine; Bosch, Aeromotive, Denso, etc.