Omg! Help Quick!
#1
Banned. I got OWNED!!!
Thread Starter
Join Date: Dec 2002
Location: wishing i was back in FL
Posts: 4,192
Likes: 0
Received 0 Likes
on
0 Posts
Omg! Help Quick!
ok, i redid the whole block off plate crap for my acv. i got gasket paper and liquid gasket stuff. i blocked it off and put gasket sealer all over. let it sit for about 3 hours, i just went out there to crank it up. OMFG!!!!! it cranks upquick and easy, shoots to 3,000 rpms! then DIES!!!! and everytime it will crank up no problem, and if i keep the rpms above 2,000 it'll stay alive. WTF!!!! it was running fine before i did this and it had a hole from acv! i'm so sad. i'm trying to adjust asap cause i need to take a 2 hour trip right now. hahahaha. HELP!!!!
-zac
-zac
#3
Senior Member
Join Date: May 2001
Location: Montreal, Quebec, Canada
Posts: 307
Likes: 0
Received 0 Likes
on
0 Posts
Sounds like a major vacuum leak: whatever you used to seal the gasket on the block-off plate didn't do the trick. Remove it and use RTV.
-John.
-John.
Last edited by FJ; 05-01-03 at 10:11 PM.
Thread
Thread Starter
Forum
Replies
Last Post
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM
Adaptronic MTX-L to adaptronic question
TeamRuffRacing
Adaptronic Engine Mgmt - AUS
1
09-30-15 08:13 PM