1st Generation Specific (1979-1985) 1979-1985 Discussion including performance modifications and technical support sections

oil press.

Thread Tools
 
Search this Thread
 
Old Jul 15, 2005 | 05:14 PM
  #1  
Bob Holton's Avatar
Thread Starter
recycled teenager
Tenured Member 05 Years
 
Joined: Feb 2004
Posts: 837
Likes: 0
From: Jackson MI USA
Question oil press.

Would a plugged or partly plugged oil sensor cause thee pressure to read low ? mine stands at 30.
Reply
Old Jul 15, 2005 | 05:35 PM
  #2  
rxseven07's Avatar
Registered pimp
Tenured Member 10 Years
 
Joined: Jan 2004
Posts: 1,286
Likes: 0
From: nashville
at idle? 35 is normal. at high rpms it should be around 75..
Reply
Old Jul 15, 2005 | 08:35 PM
  #3  
RotorMotorDriver's Avatar
Seven Is Coming
Tenured Member 20 Years
iTrader: (1)
 
Joined: Dec 2001
Posts: 6,503
Likes: 4
From: Washington
Normal oil PSI range: https://www.rx7club.com/forum/attach...hmentid=121560

Ok, how many times do I have to post that the senders go bad in these ALL THE TIME? Just go get another one from a junk yard for $5 if yours isnt working right and try that, or if you have the big bucks, go get one from the parts store for $60 and call it good. If its not working, it needs to be replaced, even if it is only clogged IMO.

~T.J.
Reply
Old Jul 16, 2005 | 07:42 AM
  #4  
Bob Holton's Avatar
Thread Starter
recycled teenager
Tenured Member 05 Years
 
Joined: Feb 2004
Posts: 837
Likes: 0
From: Jackson MI USA
Thankyou TJ Probably about as many times as I say check the fuel line filter. Bob
Reply
Old Jul 16, 2005 | 09:50 AM
  #5  
RotorMotorDriver's Avatar
Seven Is Coming
Tenured Member 20 Years
iTrader: (1)
 
Joined: Dec 2001
Posts: 6,503
Likes: 4
From: Washington
Youre welcome

I HIGHLY doubt that its a problem with your engine creating pressure. I would say that its the sender. I went through 3 in my 83 because I kept getting used ones (too broke for a new one). Ive had one die at least once in all 5 of my RX-7s.

~T.J.
Reply
Old Jul 16, 2005 | 03:35 PM
  #6  
Keith13b's Avatar
Senior Member
Tenured Member: 20 Years
iTrader: (6)
 
Joined: Jul 2005
Posts: 566
Likes: 0
From: Orlando, FL
First try to clean the electrical connector first. It gets covered in oil and can make a bad contact.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
stickmantijuana
3rd Generation Specific (1993-2002)
13
Jan 9, 2018 11:19 AM
troym55
3rd Generation Specific (1993-2002)
23
May 25, 2016 12:42 PM
tiger18
3rd Generation Specific (1993-2002)
9
Sep 3, 2015 08:27 PM
rotor_veux
2nd Generation Specific (1986-1992)
5
Sep 3, 2015 07:10 PM




All times are GMT -5. The time now is 06:33 AM.