oil gage .....not the temp
#1
nother rican witha rotary
Thread Starter
Join Date: Mar 2002
Location: S.Otown
Posts: 1,034
Likes: 0
Received 0 Likes
on
0 Posts
oil gage .....not the temp
was readin a lil past 110 after i rode around for an hr also when i turned it on it was shakin a lil i checked the oil an it smelled like gas a lil ....wha's goin on?
#2
110 is too high. There is a blockage in the oil system somewhere.
What does the oil look like? Golden brown or is it darker?
When was the last time it was changed?
What viscosity do you use?
What does the oil look like? Golden brown or is it darker?
When was the last time it was changed?
What viscosity do you use?
#4
Track that hissing noise down. It's likely an unrelated vacuum leak, but it could be an oil leak. I'm still kinda new to the old 12a, are there any vacuum lines that could cause an oil issue?
Also, check the wiring and oil pressure sensor. There have been a few posts around here where there was a loose/broken/shorted/pinched wire that led to an unusual sensor reading.
Also, check the wiring and oil pressure sensor. There have been a few posts around here where there was a loose/broken/shorted/pinched wire that led to an unusual sensor reading.
#6
Senior Member
Join Date: Nov 2002
Location: Chix Beach, Va.
Posts: 330
Likes: 0
Received 0 Likes
on
0 Posts
Dude, Same THing happened to me this week end. The oil pressure started out a little high but once I got in to the Interstate it went all the way up. Turns out I had a bad OPSU hope that is all you have wrong. Good Luck
Thread
Thread Starter
Forum
Replies
Last Post