oil coller lines

Reply Subscribe

Thread Tools

Search this Thread

Oct 13, 2005 | 01:45 PM

jason_child

Thread Starter

Full Member

Joined: Sep 2003

Posts: 193

Likes: 0

From: Canada

oil coller lines

do they have certain ways they are suppose to go on like one side for the oil cooler the other for the engine because the comp fitting on the front of the engine side is loose and pissing out oil

Oct 13, 2005 | 01:56 PM

FB II

Banned. I got OWNED!!!

Joined: Dec 2002

Posts: 4,192

Likes: 0

From: wishing i was back in FL

yes, they go on as they are now.

Oct 13, 2005 | 02:08 PM

jason_child

Thread Starter

Full Member

Joined: Sep 2003

Posts: 193

Likes: 0

From: Canada

there isn't one compression fitting that is a little longer than the other so that one side only tightens on the oil cooler side and the other tightens on the enigne side

Oct 13, 2005 | 02:21 PM

Siraniko

RX for fun

iTrader: (13)

Joined: Aug 2001

Posts: 15,926

Likes: 25

From: Socal

There is a crush washer there. Be sure to use two wrenches when installing the hoses. Use a 21mm or a 7/8 but grind it down to make it thin to match the fitting. Otherwise, you will crack the oil cooler and engine inlets.

Last edited by Siraniko; Oct 13, 2005 at 02:30 PM.

Oct 13, 2005 | 02:28 PM

FB II

Banned. I got OWNED!!!

Joined: Dec 2002

Posts: 4,192

Likes: 0

From: wishing i was back in FL

or you could go -AN fittings w/ braided lines

only about 40 bucks total WOOOOT!

Oct 13, 2005 | 03:44 PM

inuissus_cendi

---

Joined: Sep 2005

Posts: 573

Likes: 1

From: Minneapolis, MN

where'd you get braided lines and AN fittins for $40? everywhere i look they're closer to 80 or 100.

Oct 13, 2005 | 03:47 PM

x0ny

BRAP!

Joined: Jan 2005

Posts: 476

Likes: 0

From: Maryland

I just cant seem to get those stupid nuts loose on my front plate and rear, im trying to get my SE oil lines out to install braided w/ AN...any tips for that?