Number 2 Water Temp Switch (Rad)
04-18-10, 05:08 PM
#1
Number 2 Water Temp Switch (Rad)
So I am looking in the FSM and I have the number 2 water temp switch plug. I can't
find the plug anywhere on the radiator. The only wire from the radiator is on the top
censor, which I believe is the low coolant sensor. I know one of the water switches
fell off, the one on the back of the water pump housing.
Blue with black stripe, and a blue with yellow stripe wire.
#b11
find the plug anywhere on the radiator. The only wire from the radiator is on the top
censor, which I believe is the low coolant sensor. I know one of the water switches
fell off, the one on the back of the water pump housing.
Blue with black stripe, and a blue with yellow stripe wire.
#b11
04-19-10, 12:21 PM
#3
Waffles - hmmm good
iTrader: (1)
The sensor on an SA radiator is on the drivers side upper, right under the
radiator fill. On an FB its on the drivers side lower, at the very bottom of the
radiator. Both sensors thread in horizontally and stick out of the radiator on
the fan side.
Either way these are just for the cold start assist which I'm sure your
not using anymore.
radiator fill. On an FB its on the drivers side lower, at the very bottom of the
radiator. Both sensors thread in horizontally and stick out of the radiator on
the fan side.
Either way these are just for the cold start assist which I'm sure your
not using anymore.
04-19-10, 01:28 PM
#4
Moderator
iTrader: (3)
Join Date: Mar 2001
Location: https://www2.mazda.com/en/100th/
Posts: 30,855
Received 2,617 Likes
on
1,854 Posts
the EFI cars use this switch to "turn on" the emissions system.
Thread
Thread Starter
Forum
Replies
Last Post
sherff
Adaptronic Engine Mgmt - AUS
9
02-24-19 12:09 PM
josef 91 vert
2nd Generation Specific (1986-1992)
1
08-29-15 12:22 AM
befarrer
Microtech
3
08-22-15 05:52 PM