No spark to my leading blaster coil
#1
Junior Member
Thread Starter
Join Date: Aug 2006
Location: orlando fl
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
No spark to my leading blaster coil
I have to brand nem MSD blaster coils the trailing is firing just fine but my leading isnt. I went through it with a test light and i'm getting power but no spark car still runs but it'z just not as powerful WUT CAN I DO????
#2
Full Member
Join Date: May 2006
Location: Statesville, NC
Posts: 244
Likes: 0
Received 0 Likes
on
0 Posts
Assuming all the wires are hooked up correctly and making good contact, I'd check the ignitor. Leading is the one on the front of the distributor, I believe. Search or check the factory or Haynes manual and you can find the test procedure. Alternative is to swap leading and trailing. You can find used igniters from forum members or sometimes on eBay. Alternative is to switch to HEI (GM) igniters. I did a DLIDFIS setup recently with HEIs, and I love it!
Good luck,
David
Good luck,
David
Thread
Thread Starter
Forum
Replies
Last Post
The1Sun
1st Generation Specific (1979-1985)
7
09-18-15 07:13 PM
windom
Adaptronic Engine Mgmt - AUS
4
09-11-15 04:48 AM