hello everyone just wanted to say hey. and get the heads up on some things. I have owned about a dozen of 2cnd gens. but I just bought an 84 gsl. So its the first time for me doing the whole rotary carb thing. I ripped off some emmsions and so forth like i would do the 2cnd gen. but i think i took somethin off that i shouldnt have. when u start it up it idles high. also it wont hold an idle. can someone post the bare necessities that the carb needs to run??? thanks in advance

 

NOt really in help but look in VB catalogue ... i bought their colortune for engins ands its pretty sharp... it could help on a cold day !!!

 

thanks man. can someone send me a pic of what there engine looks like de emmsioned. with all the plug ups shown. so i will know what to look for and go by?!

 

In the FAQ there is a link for removing the rats nest, it has a full walkthrough of removing everything you don't need and lots of pictures.

 

yea i looked threw that. and there are a few things that are disconnected on my car that arent really showd or specified in that faq. thats y i wanna see a picture of a bare carb and motor that runs

 

no one has a pic of there car with a stripped carb/motor? also can some one send a pic to the float bowl vent solenoid valve. im not sure what that looks like

 

hmm, no pic, but its easy to spot. right underneath where your fuel lines feed the carb, there is a ***** with one single wire coming out. that is your vent solenoid, and should always open when the car is on.