New Renesis "16X" rotary engine link w/pix
#76
Junior Member
iTrader: (1)
Join Date: Dec 2003
Location: Colorado Springs
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
lol,
I have a question about the heat issue. due to the different expansion rates of iron and aluminum if you over heat the f***** your screwed, you'll warp the motor and have massive internal damage. However, with an all aluminum system is there a potential for same rate expansion and thus a little bit more room to save the motor? what about the DFI, is it true that the intake velocity is not longer important? Could you just cut massive ports into the motor and add power?
-richard
I have a question about the heat issue. due to the different expansion rates of iron and aluminum if you over heat the f***** your screwed, you'll warp the motor and have massive internal damage. However, with an all aluminum system is there a potential for same rate expansion and thus a little bit more room to save the motor? what about the DFI, is it true that the intake velocity is not longer important? Could you just cut massive ports into the motor and add power?
-richard
Thread
Thread Starter
Forum
Replies
Last Post