Need quick help with my nikki
#1
Full Member
Thread Starter
iTrader: (2)
Join Date: Apr 2007
Location: Fort worth TX
Posts: 203
Likes: 0
Received 0 Likes
on
0 Posts
Need quick help with my nikki
Ok so my gas levels were a little high in the bowls (top of the sight glass) so i pulled off the top of the carb to clean up my floats, jets, and needles. I have a couple of questions.
First off, from a spare carb i have sitting around, the needles are about 2mm longer than the ones i pulled from the original carb. I trust the original carb better, because the newer carb wasn't rebuilt very well long ago. My question is which ones do you think i should use?
Second question. There are little filters that go between were the gas comes in, and the ??retainer?? ( the thing that the needles sit in) My question is do I have to re-use these, or can I toss them because mine are quite filthy.
Thanks for reading
First off, from a spare carb i have sitting around, the needles are about 2mm longer than the ones i pulled from the original carb. I trust the original carb better, because the newer carb wasn't rebuilt very well long ago. My question is which ones do you think i should use?
Second question. There are little filters that go between were the gas comes in, and the ??retainer?? ( the thing that the needles sit in) My question is do I have to re-use these, or can I toss them because mine are quite filthy.
Thanks for reading
#2
Round and Round
iTrader: (10)
Unless you have reason to believe the needles are sticking, use the ones that were in the original carb. I wouldn't throw out the screens. Use some carb cleaner to clean them and put them back in place.
Here's some links that should help.
79-85 Carb manual
84 carb pictures
Here's some links that should help.
79-85 Carb manual
84 carb pictures
Thread
Thread Starter
Forum
Replies
Last Post
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM
Adaptronic MTX-L to adaptronic question
TeamRuffRacing
Adaptronic Engine Mgmt - AUS
1
09-30-15 08:13 PM