Need an opinion on going 13b carbed
#1
Senior Member
Thread Starter
iTrader: (2)
Join Date: Apr 2006
Location: LRAFB AR
Posts: 299
Likes: 0
Received 0 Likes
on
0 Posts
Need an opinion on going 13b carbed
As some of you know i picked up an S4 T2 short block and i am in the planing stages of putting it into my FB. I do not want to fool with to many wiring issues, because i am totally illiterate when it comes to it,so i am going carbed. My question is what type of carb could i buy that will flow enough for this engine stock. I will being rebuilding this motor myself and it will be stock port or i might be going with a small street port, i have been practicing on some old 12a irons, and if i were to go this route is there a carb that would flow enough for that. I have a 48 Dell but i dont think it is quite big enough for this particular motor.
Any suggestions would be greatly appreciated
Oh and as you can tell i will have it setup as NA for now. I just a college student and i dont have an endless supply of cash. This car will be my little sunday driver but one day it will go back to turbo just not now.
Any suggestions would be greatly appreciated
Oh and as you can tell i will have it setup as NA for now. I just a college student and i dont have an endless supply of cash. This car will be my little sunday driver but one day it will go back to turbo just not now.
Last edited by jaydun323; 03-08-07 at 02:03 AM.
#3
love the braaaap
I would suggest a 600cfm Edelbrock Performer carb. Thats what I have on my S4 13B 6 port and so far its running great. Idles extremely smooth for having a lightweight flywheel, and its uber easy to tune too.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
mulcryant
2nd Generation Specific (1986-1992)
10
09-09-15 05:24 PM