MY guages--Fuel, Oil Pressure-- don't work! Temp, tach, and speed do! Help!
#1
Senior Member
Thread Starter
Join Date: Nov 2003
Location: Shoreline, Wa
Posts: 264
Likes: 0
Received 0 Likes
on
0 Posts
MY guages--Fuel, Oil Pressure-- don't work! Temp, tach, and speed do! Help!
Just like the title, i installed my weber (its running now((thanks rob! YOure the mannnnn))) and the gas guage and oil guage are stuck on empty. Yes, i have oil and gas. Thanks!
#2
boost my 7
Join Date: Jun 2004
Location: Colfax, Washington
Posts: 884
Likes: 0
Received 0 Likes
on
0 Posts
have you dropped your gas tank at all lately??? There should be a plug that goes to it that i beleive works the fuel gauge, you should check to see if that hasnt come unplugged, but i doubt that is the problem if you havnt messed with the tank lately.
#3
Whack 'em and stack 'em
Join Date: Mar 2003
Location: Clarksburg/Bridgeport WV- North Central Appalachia
Posts: 1,373
Likes: 0
Received 0 Likes
on
0 Posts
If they worked properly before the carb swap, I would say you jiggered a wire or connection loose- or possibly yet disconnected one that should not have been disconnected?? Makes no sense multiple guages would stop working after a carb swap..
Check your fuses too.
Check your fuses too.
#4
/_\ Rotarized /_\
Join Date: Jun 2004
Location: Grand Prairie, TX
Posts: 210
Likes: 0
Received 0 Likes
on
0 Posts
not sure what to do about the gas guage, but my oil guage wasn't working until I double-checked the connection of the wire on the sensor. That fixed mine immediately. It looked like it was connected, but it wasn't on all the way.....probably barely hanging on by the gunk that had built up on it over the years.
Thread
Thread Starter
Forum
Replies
Last Post
sherff
Adaptronic Engine Mgmt - AUS
9
02-24-19 12:09 PM
immanuel__7
2nd Generation Specific (1986-1992)
89
09-05-15 10:23 AM